Air cooled condenser is a radiator work with semi-enclosed and fully enclosed compressor.
Using finned tube heat exchanger and motor-driven fan and centrifugal fan to move air through the condenser.
Adopt tube and pumice fin, through the mechanical expansion pipe, the fin and the pipe are closely adhered to each other, and the heat exchange efficiency is high.
After the leak testing by the 2.5MPa air pressure test, the factory leaves 0.05MPa ~ 0.1MPa Pressure during shipment; can be used for refrigerant such as R22, R134a, R404A, widely used in a variety of freon refrigeration equipment
Product specification of air cooled condenser
• Stainless steel, copper, aluminum, CuNi, Galvanized steel, titanium
• Aluminum, copper, stainless steel, titanium
• Thick. 1 – 4 mm
• Galvanized steel
• Stainless steel
How to use this condenser coil:
One of the most important task is to check and clean air cooled condenser coil. Excess of dirt on the coil discharge pressure will increase work.With higher than normal exhaust pressure operation system will shorten the service life of the compressor, the refrigerating capacity of the lower and more energy.
The advantages and disadvantages
There is not enough water supply source from or well.
Water quality is bad.
Heat recovery is practical and important.
Factory environment temperature will not keep at 95 ° F.
Ambient air pollution from dust and dirt particles.
Purchase and operating cost is higher
Give less cooling in hot summer.
Consume more power.
Provide supplementary heating ventilation in summer and winter.
We would be happy to make a profit for your next project, so please give us a try! You'll be pleasantly surprised.