Scientific cleaning method steps of condenser
When intelligent environmental cleaning agent in the process efficient removal of incrustation, calcium oxide, sludge and sediment, at the same time can intelligently distinguish scale and equipment material, this will not cause any
corrosion damage to the device material., and after finished cleaning can generate a layer of protective coating in the surface of equipment, to prevent corrosion protection of equipment material later.
Cleaning method:
(1) circulation cleaning: online in relation to the circulation cleaning of the heat exchange equipment.Common equipment for 3 to 5 hours to complete, large system no more than 12 hours
(2) immersion cleaning: for some small condenser, soaking method can be used for 4 to 6 hours.
(3) spray cleaning: the surface plate of large scale equipment, can use the method of spray cleaning.Cleaning process and related
Note: 1.Isolation equipment system, and drain the water from the condenser.
2.Using high pressure water to clean the pipe remaining impurities such as silt, algae, closed system.
3.In isolation valve and switch between mount ball valve (not less than 1 inch = 2.54 cm), and back to the water nozzle should be installed.
4.Connected to pump and connection pipe, make the cleaning agent from the bottom of the condenser pump, flowed from the top.
5.Needed to start pumping into the condenser of the teck cleaner (ratio) can be adjusted according to the specific circumstances.
http://www.vrcoolertech.com/condenser-coil/stainless-steel-condenser-coil.html